What Goes Into A Handcrafted Helmet Shell

Aus OurRisks
Zur Navigation springen Zur Suche springen

From there, the build follows the same certified construction as the standard range. Made to order does not mean a shortcut around testing, it means the standard process is carried out around one person's measurements and preferences instead of a general size run.

Trying a helmet on in person, and wearing it for a few minutes rather than a few seconds, catches problems a size chart alone cannot. Padding also settles slightly with use, so a helmet that feels snug when new is usually the right call.

Any impact, including a helmet dropped from a moderate height, can compress the inner liner in ways that are not visible from outside. A helmet is designed to absorb one significant impact by sacrificing that inner material, so a helmet involved in a crash should always be replaced, not inspected and reused.

A handcrafted helmet shell starts with a base material, HedonHelmets commonly fibreglass or a composite blend, layered and shaped by hand rather than produced purely by mould and machine. Each layer adds strength, and the shaping stage is where a lot of the time in production actually goes.

Anti fog inserts and coatings help in cold or wet conditions, but they are not a substitute for a visor in good condition. Once scratches build up to the point where they catch the light on every ride, it is time to replace rather than keep cleaning around the problem.

A certified helmet carries a label inside the shell showing the standard it meets, along with a homologation number that identifies the specific model tested. This label is worth checking on any helmet, since it confirms the exact helmet in your hands passed the test, not just the range it belongs to.