Getting The Right Disc For The Material And Finish You're After Saves Both Abrasives And Time, And It's Worth Checking Your Current Selection Against The Job List With A Supplier Who Stocks A Full Abrasives Range, Such As Tec Products Ltd.
Matching duty cycle to actual workload, rather than just chasing the highest amperage figure, is the difference between a machine that keeps up with the job and one that keeps tripping out halfway through it, and it's a question worth raising with a supplier before you buy, such as Tec Products Ltd.
The collet and collet body hold the tungsten in place and need to match its diameter exactly. A worn or incorrectly sized collet allows the tungsten to shift slightly during welding, which affects arc stability in ways that are easy to blame on technique when the actual cause is a consumable that needs replacing. CK Worldwide and Furick are two of the ranges we stock here, and these are inexpensive parts, but neglected ones cause a disproportionate amount of frustration at the torch.
A gas lens sits in place of the standard collet body and uses a fine mesh to straighten the shielding gas flow into a smoother, more laminar stream around the arc. This generally allows a longer stick-out from the cup without turbulence pulling in surrounding air, which is particularly useful when working in tighter joints or awkward positions where the torch needs to sit further back from the work.
Getting the right disc for the material and finish you're after saves both abrasives and time, and it's worth checking your current selection against the job list with a supplier who stocks a full abrasives range, such as Tec Products Ltd.
Abrasive discs look interchangeable on a shelf but perform very differently depending on what they're made from and what they're used on. Cutting discs are generally thin, designed to slice through material quickly with minimal heat build-up, while grinding discs are thicker and shaped to remove material from a surface or clean up a weld, rather than cut all the way through it.
Portability and durability matter depending on how the table gets used. A shop building large frames or vehicle chassis needs a solid, well-supported table that won't flex under load, while a mobile fabricator or someone working across multiple sites benefits more from a lighter, foldable design. Material and construction quality affect long-term flatness too, since a table that warps under heat from repeated welding stops being reliable exactly where it matters most.